Phaser 7750
  > Support
  > Knowledge Base
  > FAQ
  > Drivers

Support Topics
Step by step guides
  >  Errors, Jams, Failures and Other Messages
  >  Print Quality Problems
  >  General Information
  >  Installing and Setting Up the Printer, Networking
  >  Other Printing Problems
How To
  >  Install Printer Drivers
  >  Printer Setup
  >  Load Paper Trays
  >  Replace Consumables (Toner, Imaging Unit, etc.)
  >  Read the Meters



Replace / Install the Imaging Unit      

The following link displays the procedure for replacing the imaging unit in a Flash movie format and Requires the Macromedia Flash Player

Replacing the Imaging Unit

Warranty Information

  • Defective Maintenance Items replaced under warranty or service agreement will be shipped to the customer at No Charge. On-site replacement by Field Service or other authorized service partner is not covered under warranty or service agreement. To contact support in your area see the following link: Contact Us
  • If the Maintenance Items is displaying a Low or Replace message or is near the end of rated life. Please see Supplies Ordering Information for details on how to buy, supplies, pricing, and part numbers.
  1. Remove the new imaging unit from its packaging.
  2. Open the Front Door (11 KB).
  3. Push up on the bottom of the Handle Latch to release it. Then pull the Handle Latch up (25 KB).
  4. Grasp the Release Handle (25 K) in the middle and pull it down.
  5. Remove the Imaging unit by grasping the light orange front of the imaging unit (19 K) and pull it straight out.
  6. Dispose of the Imaging unit as normal office waste or recycle the imaging unit.
  7. Insert the new Imaging unit along with its black plastic protective shield in the direction of the arrow on the top of the shield and with the bottom of the shield resting on the Release Handle (19 K). Make sure the Imaging unit is in all the way.
  8. Remove the tape from the top of the Imaging unit shield (27 K) by pulling it off.


    Caution    Caution: Removing the tape will expose the print drum to light which left exposed for more then a few minutes can lower the life of the imaging unit or cause print quality degradation.

  9. While holding the imaging unit shield push the Imaging unit into the printer using the light orange triangle shaped tab (27 K). Remove the shield from the printer.
  10. Grasp the Release Handle in the middle and pull up.
  11. Push the Handle Latch down until it locks.
  12. Close the Front Door.
  13. Dispose of the protective shield and tape as normal office waste or store them for future use.

Refer to Supplies Ordering Information to order supplies.

Also see the Related items: Requires Acrobat ReaderTM

Related items
Installing the Imaging Unit (193 KB PDF file)


Document ID: R1010121091

Direct URL to this document (to bookmark this page)
http://www.xerox.com/office/phaser-7750kb/,solution=R1010121091